Description
Similar to Velcro™ but conductive. One inch wide. Excellent holding power and RF shielding. Use it to create re-sealable flaps, tubes, and seams in shielding fabrics, plastics and foils. Will conduct along its length and across the gap. Silver coated. Can be sewn in or glued, no adhesive supplied. 1 inch wide. Very unique!
Hook & Loop Fastener
Expected cycle life: 5000 openings/closings
Shear strength: 12.3 psi (new) / 6.7 psi (after 5000 cycles)
Peel strength: 1.2 piw (new) / 0.8 piw (after 5000 cycles)
Weight: 0.15 oz/in²
Mated thickness: 1/8 in
Resistivity:
Hook: 1.8 Ohm per sq
Loop: 1.4 Ohm per sq
0.8 Ohm through mated closure
Washing Instructions:
1) Softly wash by hand, with neutral detergent such as TexCare (Don’t use any strongly
alkaline detergent such as washing powder).**
2) Water temperature below 40˚C.
3) No bleach, do not use detergent with bleach ingredients.
4) Hang dry. Do not wring, do not hang in blazing sun for a long time, and pick up promptly from the water to dry.
5) Do not dry clean.
** Poor water quality will damage Silver. In particular Sulphur, high Fluoride, and low pH will
react strongly with Silver and destroy conductivity and shielding performance.
Test your tap water on a small fabric swatch before washing your fabric or garment:
1- soak a small fabric swatch in tap water for 1 hour.
2- look for color change in the water or swatch, especially blackening.
3- air dry the swatch and check for conductivity (by touching an Ohm meter to 2 points on the fabric)
If color change or loss of conductivity occurs, DO NOT use tap water to wash/rinse your fabric, use distilled or deionized, reverse osmosis water.
Washing will eventually degrade Silver coating and shielding performance. Discoloration over time is normal. It will conduct electricity. Keep away from electrical sockets and bare wires.